ferepdf.blogg.se - Evga precision x fan curve not working on second card

If the card is an EVGA graphics card, overclocking is covered under the warranty term. Please consult with your video card manufacturer before using this application. On Asus STRIX, the fans actually wont spin unless the GPU reaches a certain min TEMP threshold, though obviously we can create any custom profile, according to our need.

Remove all previous traces, and do a fresh installation of MSI AB.

Note: This application has many features and achievements that may void your graphics card's manufacturer warranty. You can also try doing a clean reinstall of any OC Software on your system first.

Profiling system allowing up to 10 profiles with hotkey.

On-Screen-Display (OSD) shows your system vitals at a glance.

New OC Scanner for finding the best stable overclock.

Dynamically set independent voltage/frequency points for ultimate control.

LED Sync that syncs with other EVGA RGB components.

RGB LED Control supporting graphics cards and/or NVLink Bridge.

Full support for GeForce RTX and select GTX Graphics Cards.

Real-Time wattage monitoring (on supported EVGA graphics cards).Brand new GUI that is faster and easier to use.When paired with an NVIDIA Turing graphics card, the new EVGA Precision X1 will unleash its full potential with a built in overclock scanner, adjustable frequency curve and RGB LED control. With a brand new layout, completely new codebase, new features and more, the new EVGA Precision X1 software is faster, easier and better than ever. The software overall is great, except the Curve setup, although I still rather use it than anything related to MSI.Introducing EVGA Precision X1. Pressing "X" will close it all up, sometimes messing up the custom settings. You also need to run X1 in the background all the time, if you tinker with the software, make sure to hit the "_" on the top right instead of "X", that way it gets minimized and just runs in the background. Easiest setup is select "Stealth", then move the lowest point to 30C and 14-15%, then check the Fan Curve Control box, and hit apply. It's also better to run the fans on a 14-15% bottom to prevent the annoyance of them turning on and off. Leaving fans on Auto is not the best solution, since if you have bad airflow and/or left your preset on "prefer maximum", your GPU on idle/desktop use will still consume over 30-40 watts, and heatsoak will be present. When you set up a custom curve, you need to do it with your mouse one by one in the default section, NOT in the VF Curve tab, then when you're done, press apply, select a preset number on the right, and press save.